Smart Lights Control System SM002HH
Features:
SercoMoto SM002HH upgrade replacement for the standard wiring harness & switch
CNC-machined aluminium switch housing
Connect straight to battery
Plug & play connectors for safety and ease of installation
Big power range support Max 75w each light.
Harness Functions:
The harness support 6 Operating mode, we make these 6 Operating modes to three sections
Section A: High Power beam,DRL(LOW power beam)
Section B: alternating strobe, two lights alternating on/off ,synchronized strobe
Section C: Pass flash
Section D: Horn flash
Section E: sync on with bike high beam
In Each section just only click switch to get function change. ( except Section C)
Double-click the switch easy to swap A.B section.
Section A:
When lights on, it default work with Section A high beam, we can click the switch from High beam to DRL(low beam) or from DRL to high beam. if we like use Section B functions we can double-click the switch to active Section B.
Section B:
Under section B we can via click switch to get 3 functions cycle change. if we like use Section B functions we can double-click the switch to active Section A.
Section C:
When lights did not turn on ,we can keep tap the switch make lights on in short time.
Section D:
When press horn over 2seconds, the lights will flash
Section E:
When bike high beam on, Auxiliary light will sync on. or if Auxiliary light on low power beam will auto
change to full power beam.
Install:
The switch install:
support 22-25mm diameter bar, or 7mm hole size fix, please refer follow picture.
Harness install
Red wire with fuse connect with battery positive part
Blue wire connect to negative part
Yellow wire is connect it to ACC wire or switch positive or the wire only bike's key on has power.
Green wire to bike high beam positive
Black wire to horn positive wire
- Contact UsDon't be afraid to reach out. You + us = awesome.